본문 바로가기
Guides

Retaining Ring Groove Chart

Spec chartsCNC machiningSep 10, 2026

A retaining ring is the simplest way to hold a bearing or bushing axially. The drawing needs two values, groove diameter and groove width, but the ring designation is often written and the groove dimensions left out. The external and internal types are listed separately.

External Retaining Ring Groove Chart (C-type for shafts)

Unit: mm. Based on shaft diameter.

Shaft diameterGroove diameterGroove widthRing thickness
109.61.11.0
1211.51.11.0
1514.31.11.0
1716.21.11.0
2019.01.31.2
2523.91.31.2
3028.61.61.5
3533.01.61.5
4037.51.851.75
5047.02.152.0

Internal Retaining Ring Groove Chart (C-type for bores)

Bore diameterGroove diameterGroove widthRing thickness
1616.81.11.0
2021.01.11.0
2526.21.31.2
3031.41.31.2
3537.01.61.5
4042.51.851.75
4749.51.851.75
5255.02.152.0

The groove width is 0.1 to 0.15 mm wider than the ring thickness. The ring must be able to rotate in the groove for assembly to work. Set the groove width tolerance at about +0.14/0, and a groove diameter of h11 for external or H11 for internal is sufficient.

Groove Position and Edge Distance

  • Leave at least 3 times the groove depth between the groove and the shaft end. If it is shorter, the end splits when the ring takes a load
  • Specify the groove bottom corner radius as 0.1 to 0.2 or less. If the radius is large, the ring will not seat fully in the groove
  • Set the axial position of the groove to the bearing width plus 0.1 to 0.3 mm of allowance. If you fit it exactly, it cannot be assembled

Common Mistakes

  • Groove width of 0.8 mm or less — Requires a thin grooving tool, which adds cost. Use the standard widths in the table
  • Internal groove deep inside a bore — If it is more than 50 mm from the bore entrance, the internal grooving tool cannot reach. Move the position forward or split the part
  • Groove diameter given but no groove width — Machining stops and a query follows. Write the two values as a pair

See Also

Drawings with grooves on shafts and bores follow rules similar to those for O-ring grooves.

Source standards: DIN 471 (external) and DIN 472 (internal), normal type. KS B 1336 (retaining rings) is in the same dimension series.

Have a part to machine?

Upload a drawing to see your quote.

Sponsorship & lab support

From competition prep to research projects,
we build alongside student teams and labs.

Questions?

KakaoTalk chat
031-509-0523